Data editing-related errors ; Device-related errors ; P.C. board-related errors - Page 147

9. TABLE OF ERROR CODES 

BAS-311G, BAS-326G 

140

Data editing-related errors 

Code 

Cause and remedy 

E500 

The enlargement ratio setting caused the sewing data to extend outside the sewing area. 
Set the enlargement ratio again. 

E501 

Sewing data that exceeds the sewing machine's sewing area was loaded. 
Check the size of the sewing data. 

E502 

The enlargement ratio caused the data pitch to exceed the maximum pitch of 12.7 mm. 
Set the enlargement ratio again. 

E510 

Invalid code in sewing data. 
Reload the data from the CF card or floppy disk. 

E511 

No end code has been input into sewing data. 
Input an end code, or change the program number. 

E512 

Number of stitches exceeds allowed maximum. 

E520 

Extended option output number already exists. Change the extended option output number. 
If not using the extended option output, initialize the data to clear the extended option output data. 

E530 

Changing program number is prohibited. 

Device-related errors 

Code 

Cause and remedy 

E600 

Upper thread breakage occurred. 
Thread the upper thread. Resewing is then possible. 

E690 

Thread nipper home position error. 
Turn off the power, and then clean underneath the needle plate to remove any dust and thread scraps. 
Check that connector P10 on the main P.C. board is properly connected. 

E691 

Thread nipper retract position error 
Check if the upper thread trailing length is too long. 
Turn off the power, and then clean underneath the needle plate to remove any dust and thread scraps. 
Check that connector P10 on the main P.C. board is properly connected. 

P.C. board-related errors 

Code 

Cause and remedy 

E700 

Abnormal rise in power supply voltage. 
Turn off the power and check the input voltage. 

E701 

Abnormal rise in sewing machine motor drive voltage. 
Turn off the power, and then check the voltage. 

E705 

Abnormal drop in power supply voltage. 
Turn off the power and check the input voltage. 

E710 

Abnormal current detected in sewing machine motor. 
Turn off the power, and then check if there are any problems with the sewing machine. 

E711 

Abnormal current detected in X-feed motor. 
Turn off the power, and then check if there are any problems in the X-feed direction. 

E712 

Abnormal current detected in Y-feed motor. 
Turn off the power, and then check if there are any problems in the Y-feed direction. 

E713 

Abnormal current detected in work clamp motor. 
Turn off the power, and then check if there are any problems with the X-feed mechanism, Y-feed mechanism or 
work clamp lifter. 

E730 

External error input (AIRSW) detected. 
Turn off the power, and then check the air pressure. 

E740 

Cooling fan does not operate. 
Turn off the power, and then check if the cooling fan is blocked with scraps of thread. 
Check that connector P22 on the main P.C. board is properly connected. 
Check if the fuse (F6) is blown. 

If an error code that is not listed above appears, contact the place of purchase.