䔀䴀䈀刀伀䤀䐀䔀刀䤀一䜀 ; 匀䔀吀唀倀; 䤀渀猀琀愀氀氀椀渀最 攀洀戀爀漀椀搀攀爀礀 昀漀漀琀 儀- Page 89

86

CONTENTS

SETTING UP

SEWING

UTILITY

STITCHES

MY CUSTOM

STITCH

TM

(CREATE

YOUR

OWN

STITCH

DESIGNS)

EMBROIDERING

MAINTENANCE

ERROR

MESSAGES

SEWING CHART

PATTERNS

(PROGRAMMED

IN MACHINE)

SETUP

EMBROIDERING

CHAPTER 5

CAUTION
Be sure to turn off the power before attaching embroidery foot Q. If the power is left on and the start/stop
button is accidentally pressed, the machine will start operating, which could result in serious injury.

Installing embroidery foot Q

5

1. Press the needle position button to raise the needle, and

then turn off the sewing machine.

2. Raise the presser foot lever.

3. With the enclosed screwdriver or disc-shaped screwdriver,

loosen the screw on the presser foot holder, and then pull
the holder downward to remove it.

1

Presser foot holder

5

4. Slide the bracket on embroidery foot Q up onto the presser

foot bar, and then fasten it by firmly tightening the screw
with the enclosed screwdriver or disc-shaped screwdriver.

1

Embroidery foot Q

CAUTION
Be careful not to touch the tip of the needle, otherwise
injuries may occur.

Note
–

Make sure that embroidery foot Q is tightly attached to the
presser foot bar.

–

It is recommended that a 90/14-size needle be used when
embroidering thicker fabrics such as denim or when using
stabilizing products such as puffy foam. A 75/11-size needle
might bend or break, which could result in injuries.