6. ASSEMBLY- Page 69

6. ASSEMBLY

BAS-311G, BAS-326G

62

18. Slide bush 

19. Bolts [4 pcs] 

20. Work clamp lifter plate assy

21. Slide block 

22. Work clamp lifter lever 

23. Work clamp lever shaft B 

24. Plain washer 

25. Retaining ring E 

26. Set screws [2 pcs] 

27. Link shoulder screw 

28. Rubber cap 

5162Q

Align 

Align the set screw with the screw stop and then tighten it so

that there is no play in the work clamp lifter lever. Check that

the work clamp lifter lever moves smoothly. 

Place the slide block onto the pin of the work clamp

lifter lever. The pin and the surface of the slide

block should be aligned. 

While aligning the slide block with the groove in the

work clamp lifter plate assembly, pass the work clamp

lever shaft B through the work clamp lifter lever. 

NOTE:

When the work clamp lifter plate assembly is

lowered, the slide block moves away, so hold the

work clamp lifter plate assembly in place until the

link shoulder screw is tightened. 

5163Q