Portable Air Compressor — If Equipped- Page 298

2021 Chrysler Pacifica Owner's Manual

Table of Contents

GETTING TO KNOW YOUR VEHICLE
CLIMATE CONTROLS
GETTING TO KNOW YOUR INSTRUMENT PANEL
WARNING LIGHTS AND MESSAGES
STARTING AND OPERATING
MULTIMEDIA
SAFETY
OCCUPANT RESTRAINT SYSTEMS
SERVICING AND MAINTENANCE
background image

296

IN CASE OF EMERGENCY

 

4. Install the remaining lug nuts with the cone 

shaped end of the nut toward the wheel. 

Lightly tighten all the lug nuts until the wheel 

sits flush onto the hub and there is no play. The 

nuts will have to be fully tightened once the 

vehicle is lowered. Tightening an improperly 

seated wheel under vehicle load can damage 

the threads, cause vibration, and undermine 

safety.

5. Lower the vehicle to the ground by turning the 

jack handle counterclockwise.

6. Finish tightening the lug nuts. Push down on 

the wrench while at the end of the handle for 

increased leverage. Tighten the lug nuts in a 

star pattern until each nut has been tightened 

twice  

Ú

page 362. If in doubt about the 

correct tightness, have them checked with a 

torque wrench by an authorized dealer or at a 

service station.

7. After 25 miles (40 km) check the lug nut 

torque with a torque wrench to ensure that all 

lug nuts are properly seated against the wheel.

P

ORTABLE

 A

IR

 C

OMPRESSOR

 —

I

F

 E

QUIPPED

Your vehicle may be equipped with a Portable Air 

Compressor. Use the Portable Air Compressor 

located in the side compartment of the cargo area 

to inflate the inflatable tire to 60 psi (4.2 Bar).

Portable Air Compressor

Portable Air Compressor Usage With Inflatable 

Spare Tire
1. Remove the Portable Air Compressor from the 

storage location.

2. Raise the vehicle as described in 

the Jacking Instructions within this 

section.
3. Install the Inflatable Spare tire as 

described in the Jack Instructions 

section in this manual. Make sure 

that the valve stem is located near 

the ground, and then screw the air hose of the 

Portable Air Compressor to the valve stem.

4. Uncoil the power plug and connect 

it the vehicles 12 Volt power Outlet.

5. Always start the engine before 

turning ON the Portable Air 

Compressor.
6. Switch the power button ON.

7. Inflate the tire to 60 psi (4.2 Bar) 

recommended as per the label on 

the wheel or if the vehicle equipped 

with the inflatable spare tire 

pressure indicated on the Tire and Loading 

information label located on the driver-side 

door opening.

WARNING!

To avoid the risk of forcing the vehicle off the 

jack, do not tighten the wheel nuts fully until the 

vehicle has been lowered. Failure to follow this 

warning may result in serious injury.

1 — Power Plug
2 — Deflation Button
3 — Pressure Gauge
4 — Power Button
5 — Air Hose

21_RUP_OM_EN_USC_t.book  Page 296  

Detailed Information for 2021 Chrysler Pacifica Owner's Manual

Lists of information found in 2021 Chrysler Pacifica Owner's Manual - Page 298

  • 4. Install the remaining lug nuts with the cone shaped end of the nut toward the wheel.
  • 5. Lower the vehicle to the ground by turning the jack handle counterclockwise.
  • 6. Finish tightening the lug nuts.
  • 62. If in doubt about the correct tightness, have them checked with a torque wrench by an authorized dealer or at a service station.
  • 7. After 25 miles (40 km) check the lug nut torque with a torque wrench to ensure that all lug nuts are properly seated against the wheel.
  • 4.2 Bar).
  • 1. Remove the Portable Air Compressor from the storage location.
  • 2. Raise the vehicle as described in the Jacking Instructions within this section.
  • 3. Install the Inflatable Spare tire as described in the Jack Instructions section in this manual.
  • 4. Uncoil the power plug and connect it the vehicles 12 Volt power Outlet.
  • 5. Always start the engine before turning ON the Portable Air Compressor.
  • 6. Switch the power button ON.
  • 7. Inflate the tire to 60 psi (4.

Related Documents for 2021 Chrysler Pacifica Owner's Manual