IN CASE OF EMERGENCY- Page 303

2021 Chrysler Pacifica Owner's Manual

Table of Contents

GETTING TO KNOW YOUR VEHICLE
CLIMATE CONTROLS
GETTING TO KNOW YOUR INSTRUMENT PANEL
WARNING LIGHTS AND MESSAGES
STARTING AND OPERATING
MULTIMEDIA
SAFETY
OCCUPANT RESTRAINT SYSTEMS
SERVICING AND MAINTENANCE
background image

IN CASE OF EMERGENCY

301

If the tire inflates to the recommended pressure or 

is at least 26 psi (1.8 Bar) pressure within 

15 minutes:

NOTE:

If the tire becomes overinflated, push the Deflation 

Button to reduce the tire pressure to the recom

-

mended inflation pressure before continuing.

1. Push the Power Button to turn the 

Tire Service Kit off.

2. Remove the speed limit label from 

the Tire Service Kit and place sticker 

on the steering wheel.

3. Immediately disconnect the Sealant Hose 

from the valve stem, reinstall the cap on the 

fitting at the end of the hose, and place the Tire 

Service Kit in the vehicle storage location.

Drive Vehicle:

 Immediately after injecting sealant and 

inflating the tire, drive the vehicle 5 miles 

(8 km) or 10 minutes to ensure 

distribution of the Tire Service Kit Sealant 

within the tire. Do not exceed 50 mph (80 km/h).

After Driving:

Pull over to a safe location and turn on the 

vehicle’s Hazard Warning Flashers.

Verify that the valve stem (on the wheel with the 

deflated tire) is in a position that is near to the 

ground. This will allow the Tire Service Kit Hose 

to reach the valve stem and keep the Tire 

Service Kit flat on the ground. This will provide 

the best positioning of the kit when injecting the 

sealant into the deflated tire and running the air 

pump. Move the vehicle as necessary to place 

the valve stem in this position before 

proceeding.

Place the transmission in PARK (P) and cycle the 

ignition in the OFF position.

Apply the parking brake.

NOTE:

If tire has improper inflation follow the steps below
1. Uncoil the Sealant Hose, and then remove the 

cap from the fitting at the end of the hose.

2. Place the Tire Service Kit flat on 

the ground next to the deflated tire.

3. Remove the cap from the valve stem, and then 

screw the fitting at the end of the Sealant Hose 

onto the valve stem.

4. Uncoil the Power Plug and insert 

the plug into the vehicle's 12 Volt 

power outlet.
5. Uncoil the Hose and screw the 

fitting at the end of the hose onto the 

valve stem.
6. Turn the Mode Select Knob and 

turn to the Air Mode position.
7.Check the pressure in the tire by 

reading the Pressure Gauge.

If tire pressure is less than 19 psi (1.3 Bar):
The tire is too badly damaged. Do not attempt to 

drive the vehicle further. Call for assistance.

WARNING!

The Tire Service Kit is not a permanent flat tire 

repair. Have the tire inspected and repaired or 

replaced after using the Tire Service Kit. Do not 

exceed 50 mph (80 km/h) until the tire is 

repaired or replaced. Failure to follow this 

warning can result in injuries that are serious or 

fatal to you, your passengers, and others around 

you. Have the tire checked as soon as possible 

at an authorized dealer.

7

21_RUP_OM_EN_USC_t.book  Page 301  

Detailed Information for 2021 Chrysler Pacifica Owner's Manual

Lists of information found in 2021 Chrysler Pacifica Owner's Manual - Page 303

  • 1.8 Bar) pressure within 15 minutes: NOTE: If the tire becomes overinflated, push the Deflation Button to reduce the tire pressure to the recom - mended inflation pressure before continuing.
  • 1. Push the Power Button to turn the Tire Service Kit off.
  • 2. Remove the speed limit label from the Tire Service Kit and place sticker on the steering wheel.
  • 3. Immediately disconnect the Sealant Hose from the valve stem, reinstall the cap on the fitting at the end of the hose, and place the Tire Service Kit in the vehicle storage location.
  • 1. Uncoil the Sealant Hose, and then remove the cap from the fitting at the end of the hose.
  • 2. Place the Tire Service Kit flat on the ground next to the deflated tire.
  • 3. Remove the cap from the valve stem, and then screw the fitting at the end of the Sealant Hose onto the valve stem.
  • 4. Uncoil the Power Plug and insert the plug into the vehicle's 12 Volt power outlet.
  • 5. Uncoil the Hose and screw the fitting at the end of the hose onto the valve stem.
  • 6. Turn the Mode Select Knob and turn to the Air Mode position.
  • 7.Check the pressure in the tire by reading the Pressure Gauge.
  • 1.3 Bar): The tire is too badly damaged.

Related Documents for 2021 Chrysler Pacifica Owner's Manual