Shipping the printer; Saving energy and paper; Setting up power saver modes- Page 68

CAUTION—POTENTIAL INJURY: 

When moving the printer, follow these guidelines to avoid personal

injury or printer damage:

•

Make sure that all doors and trays are closed.

•

Turn off the printer, and then unplug the power cord from the electrical outlet.

•

Disconnect all cords and cables from the printer.

•

If the printer has a caster base, then carefully roll it to the new location. Use caution when passing over
thresholds and breaks in flooring.

•

If the printer does not have a caster base but is configured with optional trays, then lift the printer off the
trays. Do not try to lift the printer and the trays at the same time.

•

Always use the handholds on the printer to lift it.

•

Any cart used to move the printer must have a surface able to support the full footprint of the printer.

•

Any cart used to move the hardware options must have a surface able to support the dimensions of the
options.

•

Keep the printer in an upright position.

•

Avoid severe jarring movements.

•

Make sure that your fingers are not under the printer when you set it down.

•

Make sure that there is adequate clearance around the printer.

Note: 

Damage to the printer caused by improper moving is not covered by the printer warranty.

Shipping the printer

For shipping instructions, go to 

http://support.lexmark.com

 or contact customer support.

Saving energy and paper

Setting up power saver modes

Eco

‑

Mode

1

From the home screen, touch 

Settings

 > 

Device

 > 

Power Management

 > 

Eco

‑

Mode

.

2

Select a setting.

Sleep mode

1

From the home screen, touch 

Settings

 > 

Device

 > 

Power Management

 > 

Timeouts

 > 

Sleep Mode

.

2

Enter the number of minutes the printer stays idle before it enters Sleep mode.

Hibernate mode

1

From the home screen, touch 

Settings

 > 

Device

 > 

Power Management

 > 

Timeouts

 > 

Hibernate Timeout

.

2

Select the amount of time before the printer enters hibernate mode.

Notes:

•

Make sure to wake the printer from hibernate mode before sending a print job.

Maintaining the printer

68