Installing a printer hard disk; Note: ; Warning—Potential Damage: - Page 126

4

Push the card firmly into place.

Note: 

The entire length of the connector on the card must touch and be flush against the controller

board.

Warning—Potential Damage: 

Improper installation of the card may cause damage to the card and the

controller board.

5

Reattach the access cover.

6

Connect the power cord to the electrical outlet, and then turn on the printer.

CAUTION—POTENTIAL INJURY: 

To avoid the risk of fire or electrical shock, connect the power cord

to an appropriately rated and properly grounded electrical outlet that is near the product and easily
accessible.

Installing a printer hard disk

CAUTION—SHOCK HAZARD: 

To avoid the risk of electrical shock, if you are accessing the controller

board or installing optional hardware or memory devices sometime after setting up the printer, then turn
the printer off, and unplug the power cord from the electrical outlet before continuing. If you have any
other devices attached to the printer, then turn them off as well, and unplug any cables going into the
printer.

1

Turn off the printer, and then unplug the power cord from the electrical outlet.

2

Using a flat

‑

head screwdriver, remove the controller board access cover.

Upgrading and migrating

126