Selectable Tire Fill Alert — If Equipped; TPMS Deactivation — If Equipped- Page 342

2021 Jeep Gladiator Owner's Manual

Table of Contents

GETTING TO KNOW YOUR VEHICLE
GETTING TO KNOW YOUR INSTRUMENT PANEL
WARNING LIGHTS AND MESSAGES
STARTING AND OPERATING
MULTIMEDIA
SAFETY
OCCUPANT RESTRAINT SYSTEMS
SERVICING AND MAINTENANCE
VEHICLE MAINTENANCE
TECHNICAL SPECIFICATIONS
background image

340

SAFETY

 

SELECTABLE TIRE FILL ALERT — IF EQUIPPED

The Selectable Tire Fill Alert (STFA) system is an 

optional feature that is included as part of the 

normal Tire Fill Alert system. The system is 

designed to allow you to select a pressure to 

inflate or deflate the vehicle's front and rear 

axle tires to, and to provide feedback while 

inflating or deflating the vehicle's tires.
In the Selectable Tire Fill Alert application, 

which is located in the apps menu of the 

Uconnect system, you will be able to select a 

pressure setting for both the front and rear axle 

tire pressures by scrolling through a pressure 

range from XX to 15 psi in 1 psi increments for 

each axle setting.
XX = the vehicle's cold placard pressure values 

for the front and rear axles as shown on the 

vehicle placard pressure label.
You may also store pressure values chosen for 

each axle in the Uconnect system application as 

preset pressure values. Up to two sets of preset 

pressure values can be stored in the Uconnect 

system for the front and rear axle. Once you 

select the tire pressures for the front and rear 

axles that you want to inflate or deflate to, you 

can begin inflating or deflating one tire at a 

time.

NOTE:

The STFA system will only support inflating or 

deflating one tire at a time.
The system will be activated when the TPMS 

receiver module detects a change in tire 

pressure. The ignition must be in the ON/RUN 

mode, with the transmission in PARK in vehicles 

with an automatic transmission, and in 

NEUTRAL with the parking brake engaged in 

vehicles with a manual transmission. The 

hazard lamps will come on to confirm the 

vehicle is in Tire Fill Alert mode.
When Tire Fill Alert Mode is entered, the tire 

pressure screen will be displayed in the 

instrument cluster. If the hazard lamps do not 

come on while inflating or deflating the tire, the 

Tire Pressure Monitoring System (TPMS) sensor 

may be in an inoperative position, preventing 

the TPMS sensor signal from being received. In 

this case, the vehicle may need to be moved 

slightly forward or backward.

Horn chirps will indicate STFA status as tires are 

inflated/deflated. The horn will chirp under the 

following STFA states:
1. The horn will chirp once when the selected 

pressure is reached to let you know when 

to stop inflating or deflating the tire.

2. The horn will chirp three times if the tire is 

overinflated or over-deflated.

3. The horn will chirp once again when enough 

air is added or removed to reach proper 

selected pressure level.

TPMS DEACTIVATION — IF EQUIPPED

The TPMS can be deactivated if replacing all 

four wheel and tire assemblies (road tires) with 

wheel and tire assemblies that do not have 

TPMS sensors, such as when installing winter 

wheel and tire assemblies on your vehicle.
To deactivate the TPMS, first replace all four 

wheel and tire assemblies (road tires) with tires 

not equipped with Tire Pressure Monitoring 

System (TPMS) sensors. Then, drive the vehicle 

for 20 minutes above 15 mph (24 km/h).

21_JT_OM_EN_USC_t.book  Page 340  

Detailed Information for 2021 Jeep Gladiator Owner's Manual

Lists of information found in 2021 Jeep Gladiator Owner's Manual - Page 342

  • 1. The horn will chirp once when the selected pressure is reached to let you know when to stop inflating or deflating the tire.
  • 2. The horn will chirp three times if the tire is overinflated or over-deflated.
  • 3. The horn will chirp once again when enough air is added or removed to reach proper selected pressure level.

Related Documents for 2021 Jeep Gladiator Owner's Manual