SERVICING AND MAINTENANCE
439
Adding Fluid
Add lubricant only at the fill hole and only to the
level specified above.
Selection Of Lubricant
Use only the manufacturer’s recommended
T
RANSFER
C
ASE
Fluid Level Check
The fluid level should be to the bottom edge of
the fill hole when the vehicle is in a level
position.
Transfer Case
Drain And Refill
For the proper maintenance intervals
Selection Of Lubricant
Use only the manufacturer’s recommended
M
ANUAL
T
RANSMISSION
— I
F
E
QUIPPED
Fluid Level Check
Check the fluid level by removing the fill plug.
The fluid level should be between the bottom of
the fill hole and a point not more than 3/16 of
an inch (4.76 mm) below the bottom of the
hole.
Add fluid, if necessary, to maintain the proper
level.
Frequency Of Fluid Change
Under normal operating conditions, the fluid
installed at the factory will give satisfactory
lubrication for the life of the vehicle. If the fluid
becomes contaminated with water, it should be
changed immediately. Otherwise, change the
fluid as recommended in the Maintenance Plan
Selection Of Lubricant
Use only manufacturer's recommended manual
A
UTOMATIC
T
RANSMISSION
—
I
F
E
QUIPPED
Special Additives
It is strongly recommended against using any
special additives in the transmission. Automatic
Transmission Fluid (ATF) is an engineered
product and its performance may be impaired
by supplemental additives. Therefore, do not
add any fluid additives to the transmission.
Avoid using transmission sealers as they may
adversely affect seals.
1 — Fill Hole
2 — Drain Hole
CAUTION!
Do not use chemical flushes in your
transmission as the chemicals can damage
your transmission components. Such damage
is not covered by the New Vehicle Limited
Warranty.
8
21_JT_OM_EN_USC_t.book Page 439