(7) Checking Sensor and Switch for GST; Traveling Speed Sensor; Wire Harness Side- Page 687

Kubota L3560 Owners Manual

2014 Dodge Charger SRT Owner Manual

Table of Contents

L3560,L4060,L4760,L5060,L5460,L6060
9 ELECTRICAL SYSTEM
background image

ELECTRICAL SYSTEM

L3560, L4060, L4760, L5060, L5460, L6060, WSM

9-S49

Traveling Speed Sensor

1. Measure  the  resistance  between  terminal 

7

  of  main  ECU

connector 

B

 and terminal 

2

 of sensor connector.

2. If 0 ohm is not indicated, the wiring harness is faulty.

NOTE

• It is not necessary to adjust any kind of mode.

9Y1210824ELS0042US0

(7) Checking Sensor and Switch for GST

GST Lever Sensor Resistance

1. Measure the resistance between terminal 

a

 (1) and 

c

 (3).

2. Then, check resistance between terminal 

a

 (1) and 

b

 (2) while

slowly turning the sensor shaft.

3. It is OK if the resistance value approximates to the value shown

in the table below.

NOTE

• When replacing the sensor, be sure to adjust the mode "E".

(Reference)

• The  change  of  resistance  can  be  checking  easily  when  an

analog tester is employed.

9Y1210824ELS0043US0

Resistance

Terminal 

2

 of sensor 

connector – Terminal 

7

 

of main ECU 

connector 

B

0 Ω

Terminal 

3

 of sensor 

connector – Chassis

(1) Traveling Speed Sensor

(2) Terminal 

1

(3) Terminal 

2

(4) Terminal 

3

A : Connector of Wire Harness Side
B : Main ECU Connector B (34P) of 

Wire Harness Side

Resistance

Terminal 

a

 – Terminal 

c

1.6 to 2.4 kΩ

Terminal 

a

 – Terminal 

b

Resistance is normal if 

smoothly changing

(1) Terminal 

a

(2) Terminal 

b

(3) Terminal 

c

(4) GST Lever Sensor

KiSC issued 03, 2016 A

Detailed Information for Kubota L3560 Owners Manual

Lists of information found in Kubota L3560 Owners Manual - Page 687

  • 1. Measure the resistance between terminal 7 of main ECU connector B and terminal 2 of sensor connector.
  • 2. If 0 ohm is not indicated, the wiring harness is faulty.
  • 1. Measure the resistance between terminal a (1) and c (3).
  • 2. Then, check resistance between terminal a (1) and b (2) while slowly turning the sensor shaft.
  • 3. It is OK if the resistance value approximates to the value shown in the table below.
  • 1.6 to 2.
  • It is not necessary to adjust any kind of mode.
  • When replacing the sensor, be sure to adjust the mode "E".
  • The change of resistance can be checking easily when an analog tester is employed.

Related Documents for Kubota L3560 Owners Manual